| Picture |
Heading |
Updated |
 |
T-Handle Wire Starter Tool
Model Number: A717201
Key Specifications/Special Features:
Stainless steel with contoured T-handle for added grip and comfortDesigned for feeding / starting wire through bonding on windscreenLength: 330 mmOEM/ODM orders are welcomeBlade: stain... |
2017-12-27 |
 |
Injector Cap Removal Socket Set
Model Number: A913504
Key Specifications/Special Features:
Removes the top cap and connectors on diesel fuel injectors prior to injector removalDeep socket and wide cut-out configuration are essential for this applicationFits the most popular ... |
2017-10-11 |
 |
5-piece Trim Fastener and Molding Removal Set for Automotive Repair/Maintain Tools
Model Number: A622205B
Key Specifications/Special Features:
The most versatile body/interior toll set we have evercarriedNearly indestructible, non-marring composite constructionGreat for technicians, body shops and upholstery shopsPacking: slid... |
2017-09-11 |
 |
Inner Bearing Ring Extraction Tool Set for Automotive Repair/Maintain Tools
Model Number: A905510
Key Specifications/Special Features:
Allows precise extraction of inner bearing race from the wheel hubRemoval of the hub almost always leaves the inner race on the hubThe race is impossible to remove without the correct ... |
2017-09-06 |
 |
5-Piece Hook and Magnetic Pick-Up Tool
Model Number: 602205M
Key Specifications/Special Features:
5-piece hook and magnetic pick-up tool:Straight pickHook pick90-degree pickO-ring pickExtension magneticPacked in a pouch bag
Main Export Markets:
Eastern EuropeNorth AmericaMid East... |
2017-08-31 |
 |
4pcs Ignition Coil Remover Set
Model Number: A513504
Key Specifications/Special Features:
A: for removing and installing ignition coils with power stage VW Golf, Bora, Passat, Sharan, Touareg, Phaeton, Touareg 6 CylB: fast and safe removing and installing of ignition coilsFor... |
2017-08-07 |
 |
Universal Bearing Packer with 4-1/4-Inch Cone Diameter
Model Number: 623201
Key Specifications/Special Features:
Fast and efficientSimply place the bearing between the plastic cones, tighten, and apply grease through the fitting on the end of thread shaftForces out old grease and evenly injects fres... |
2017-07-31 |
Friends links